2 Reflectors FIT HP Scitex FB500 FB550 FB700 FB750 EUV Lamp Shutter Motion ERROR

  

Being offered is this lot of 2 new, (still has plastic film in place that protects the reflectors mirror surface - must remove before using), main, rear section/piece of shutter reflector assembly that will FIT both service end and/or user end shutter assemblies of. Scitex FB 500's and FB700's and the newer FB550's, FB750's and FB950's. As anyone who has worked on these machines knows; o. Ver time, the rear main reflector of the shutter will developed stress cracks from its repetitive motion (where it is riveted in place-see pictures of typical reflector fail). These cracks will result in the reflector coming loose, rubbing on other.

Components within the shutter assembly. And obstructing the free motion of the shutters pivoting reflector. Once this occurs, the pivoting mirror will make excessive noise and finally throw "UV shutter" or "UV Lamp Motion Error" and refuse to run. Why replace the whole assembly?

Replace the mirror at 10th of the cost. That is what I do; and it works! Simply remove rivets that holds the damaged mirror in place I found that using a Dremel tool to carefully, grind the head of the rivets off and pushing the rivets out, works best.

Using a drill has the potential of making the original, mating, mounting holes oversize, resulting in an undesirable, sloppy fit. You want to maintain the tight fit to minimize movement during shutter movement. Just be sure to cover circuitry and direct the flying debris away and firmly tighten this NEW Reflector in place, using the fasteners I will provide (red thread lock is NOT SUPPLIED but is highly recommended on the two fasteners used to replace the rivets). Once the new mirror is installed, pivot the mirror to confirm free motion before installation.

Also after you install the new reflector, you may need to recalibrate the shutter assembly for optimum operation. This is a simple task using the machines touch screen, that I will gladly provide instruction written procedures (with the buyers request). So even if it is not broken today; you know it is going to happen.

And how much production will you lose. It is not just me saying this; see comments I received below from buyers worldwide. JUST INSTALLED & IT WORKS PERFECTLY. Figured it was worth a shot..

Item was as described and worked great. It fit like a Glove! I followed your instructions, installation was easier than I expected. I installed the reflector last week and it has been working very well.

Worked with me to get it overnight. NOTE: You are purchasing ONLY the piece shown in first 4 pictures (Qty of 2 identical pieces). These are various views of an actual, single piece you will receive.

Off-and 2nd- 4th the film is still on, and slightly. Back for hardware installation, hence the dull finish - The 5th and 6th pictures show a typical example of failed part in whole assembly-(assembly IS NOT INCLUDED). I still do have more.

So; if you are cautious and would like try 1 of these rear reflectors to start with. THIS MIRROR WILL FIX A SHUTTER ERROR THAT IS CAUSED BY A CRACKED MIRROR ONLY. I will answer all questions to the best of my ability.

I now offer the side, link, bridge, reflectors for these assemblies! I do have many other vintage items for sale. Please take the time to look at our other items!

This service is described as 3-5 day to many major markets. And "this is based upon average performance to major markets, and the actual transit time may vary for origin and destination". Please understand it is not meant to be rude, but is a matter of being treated fairly the same as buyers expect to be treated. Although most buyers are very good about paying for their items, there are a few who must be told....