Uses: Hob is an indispensable tool for cutting all kinds of photographic paper, film, art cardboard, hot and cold crepe paper, thin plastic sheets and thin copper. Widely used in photography studios, photography museums, big head shops and related office space. The hob adopts automatic paper weighting design, self-grinding roller blade and grinding tool body, which makes the hob automatically sharpen and durable.
The cutting size is in centimeters and inches, convenient, fast, safe and practical. Avoid paper transfer and paper feed.
The finished product has no burrs, which is an effect that ordinary cutters cannot achieve. It can cut a variety of photographic papers without sharpening the tool or changing the blade regularly. Film, hot and cold paper, art paper cardboard, office paper, thin plastic soft board, rubber soft board, copper treasure, aluminum, PVC, etc. Makes the hob automatically sharpen in use and durable. The blade is sharp, not only can cut ten copies at a time.
PVC cards are also easily cut off. When cutting, the knife box should be evenly applied in the direction of the guide rod. Do not apply force in other directions.
After the work is completed, park the knife box at one end of the guide. For safety reasons, do not touch the blade with your hand. As shown in Figure, the blade typically does not need to be replaced, but when the blade is slotted or deformed and the blade becomes dull and unusable, the blade needs to be replaced.Flatten the paper to be cut under the plexiglass ruler and prepare it on the cutting table according to the required size. Pull the knife box from one end to the other to complete the work.
When cutting, the tool holder should be evenly applied in the direction of the guide rod. After completing the work, stop the knife box at one end of the guide. For your safety, do not touch the blade with your hand. The blade usually does not need to be replaced, but when the blade is notched or deformed and the blade is dull and unusable, the blade needs to be replaced. When the model is 24 inches or larger, move the knife box (3) to the center of the table, then directly flip the knife box to the outside of the table, so that the blade is in the visible position, but not too strong, so as not to guide The rod is deformed.
Use a micro screwdriver to remove the top screw (1) from the knife box, then use the wire cutter to gently pull down the shaft (8) to remove the mold (5). Insert the special wrench into the mold hole and the round nut and turn it counterclockwise to remove the blade. When the knife box is installed, the blade plane is close to the lower blade, and the chamfered surface of the blade should be outward. Feedback is very important to us. It is impossible to address issues if we do not know about them!Faction is our ultimate goal. We work hard to earn your trust and future business. A If you receive a defective item, you may return it or ask for a discount. Due to time zones, our reply to your questions may not be immediately. If it's non-workdays, please kindly be patient and wait till Monday. This item is in the category "Business & Industrial\Printing & Graphic Arts\Bindery & Finishing Equipment\Paper Cutters & Trimmers". The seller is "yybshop02" and is located in this country: US. This item can be shipped to United States.